Page 1 of 1

Missing ineterface for ID: 2C6, 2C7, 2CA, and 2CB

Posted: Wed May 24, 2023 11:40 am
by sara
So when I open a car it will show me the maping but not the acual car, and gives me the error code Missing Serializeable for System.Solid, missing interface for id 2C6, missing interface for id 2C7, missing interface for id 2CA, and missing interface for id 2CB. I payed for a month and realy what to make some cars if someone could help me, that would be lovely.

Re: Missing ineterface for ID: 2C6, 2C7, 2CA, and 2CB

Posted: Fri May 26, 2023 7:34 am
by Oleg
Hello.

When you open a .z3d file that was saved by older ZModeler version, several "Missing Serializeable" is OK. In particular, there are no longer "System.Solid" or "System.Wireframe" shaders in ZModeler, so they will always be missing when you open an old .z3d file. Actually, this should have no any impact on your scene after loading such a file in new ZModeler version.

Re: Missing ineterface for ID: 2C6, 2C7, 2CA, and 2CB

Posted: Fri May 26, 2023 7:59 pm
by sara
ok but when I open it all I can see is thisImage

Re: Missing ineterface for ID: 2C6, 2C7, 2CA, and 2CB

Posted: Sat May 27, 2023 6:04 am
by Oleg
You should toggle L0 or L1 button on Structure panel. These are states (level of detail) on compound objects - objects that can store different objects inside for different states.

It was this way since release of ZModeler3, this is not something new in ZModeler 3.3.0.