Zmodeler 3 "The Parameter is incorrect" error

Technical issues and help in: forum registration/posting, account creation/confirmation, platforms and licenses issues.

Moderator: Oleg

Turbo Elco Models
Posts: 1
Joined: Sun Jan 08, 2023 7:49 pm

Zmodeler 3 "The Parameter is incorrect" error

Post by Turbo Elco Models »

Hello everyone I'm getting a The Parameter is incorrect error when trying to open a file that was on a hard drive that was corrupted. can anyone fix it? thanks.
User avatar
Oleg
Site Admin
Posts: 14044
Joined: Fri Feb 06, 2004 3:54 am
Contact:

Re: Zmodeler 3 "The Parameter is incorrect" error

Post by Oleg »

most likely some geometry object is damaged there and ZModeler fails to draw it. I advise to try to recover objects from this file using File\Merge. You can try to get first group of objects in one attempt, then merge again and get another group of objects and so on.
genijim
Posts: 1
Joined: Tue Jan 17, 2023 11:41 pm

Re: Zmodeler 3 "The Parameter is incorrect" error

Post by genijim »

Oleg wrote: Mon Jan 09, 2023 5:12 am most likely some geometry object is damaged there and ZModeler fails to draw it. I advise to try to recover objects from this file using File\Merge. You can try to get first group of objects in one attempt, then merge again and get another group of objects and so on.
I have the same situation and recovering objects from the file solve the problem. Thank you Oleg for your advice.
Post Reply