How to save the position of a bone already created?

SCS Software ATS and ETS2 editing using ZModeler3 filter. Models, Materials, Animation.

Moderator: Oleg

Post Reply
LeynerN31
Posts: 71
Joined: Thu Jan 27, 2022 6:05 pm

How to save the position of a bone already created?

Post by LeynerN31 »

I have this doubt and I always struggle to achieve it, when you deactivate the setup mode and move the bone next to the geometry, when deactivating setup mode or exporting the position it returns to the original, how can I do so that the edition of the position of the bone is saved ?
User avatar
Oleg
Site Admin
Posts: 14045
Joined: Fri Feb 06, 2004 3:54 am
Contact:

Re: How to save the position of a bone already created?

Post by Oleg »

setup mode is the position/rotation of bones that is actually saved. Non-setup mode is a "relative to setup" changes (usually by animation playback) that transforms geometry from default position. So, in general, setup mode is the one you should use to assign bones positions/rotations for export.
Post Reply