Separate pieces through uv map

SCS Software ATS and ETS2 editing using ZModeler3 filter. Models, Materials, Animation.

Moderator: Oleg

Post Reply
User avatar
yandry
Posts: 87
Joined: Wed Oct 21, 2020 4:43 pm

Separate pieces through uv map

Post by yandry »

Is there a way to separate the pieces once it has been done since I would like to map only a specific part and not have to do the part separation process manually

https://ibb.co/2P5c3jF
User avatar
Oleg
Site Admin
Posts: 14044
Joined: Fri Feb 06, 2004 3:54 am
Contact:

Re: Separate pieces through uv map

Post by Oleg »

Not sure what exactly are you trying to do. You can right-click in UV mapper on some element in UV Mapper and pick "Select->Target". This will perform selection of original mesh elements, so you can use "Detach" then.
User avatar
yandry
Posts: 87
Joined: Wed Oct 21, 2020 4:43 pm

Re: Separate pieces through uv map

Post by yandry »

Oleg wrote: Fri Jan 22, 2021 8:48 pm Not sure what exactly are you trying to do. You can right-click in UV mapper on some element in UV Mapper and pick "Select->Target". This will perform selection of original mesh elements, so you can use "Detach" then.
Yes, thank you very much I have already been able to separate the pieces already mapped <3
Post Reply