Zmodeler 3 "The Parameter is incorrect" error
Moderator: Oleg
-
- Posts: 1
- Joined: Sun Jan 08, 2023 7:49 pm
Zmodeler 3 "The Parameter is incorrect" error
Hello everyone I'm getting a The Parameter is incorrect error when trying to open a file that was on a hard drive that was corrupted. can anyone fix it? thanks.
Re: Zmodeler 3 "The Parameter is incorrect" error
most likely some geometry object is damaged there and ZModeler fails to draw it. I advise to try to recover objects from this file using File\Merge. You can try to get first group of objects in one attempt, then merge again and get another group of objects and so on.
Re: Zmodeler 3 "The Parameter is incorrect" error
I have the same situation and recovering objects from the file solve the problem. Thank you Oleg for your advice.Oleg wrote: ↑Mon Jan 09, 2023 5:12 am most likely some geometry object is damaged there and ZModeler fails to draw it. I advise to try to recover objects from this file using File\Merge. You can try to get first group of objects in one attempt, then merge again and get another group of objects and so on.