commands missing on the commands bar

Troubleshooting gudes, solutions and other ZModeler3-related discussion

Moderators: Oleg, madga182

commands missing on the commands bar

Postby firstmada » Mon Apr 10, 2017 10:59 pm

basically when I go to the commands bar and click any sub command e.g. select the available options e.g. quadr is not there PIC:
however I then found where they have gone as there is a arrow that when clicked drops a menu down and shows all the options that there should be PIC:
but how do I get it back the options being directly under there options instead of being under the arrow drop down menu?
Posts: 11
Joined: Fri Aug 21, 2015 7:46 am

Re: commands missing on the commands bar

Postby Oleg » Tue Apr 11, 2017 3:57 am

resize bar vertically, so it can fit buttons. then you can resize buttons (and group-buttons) height/width by holding CTRL key. once height on all buttons is reduced, you can reduce height of commands bar too.
User avatar
Site Admin
Posts: 7390
Joined: Fri Feb 06, 2004 3:54 am

Return to ZModeler3 General discussion

Who is online

Users browsing this forum: No registered users and 1 guest