Hi Oleg
I have a problem with the license validation
[EDIT] Make sure you don't have an extra copy running,arghh
Unable to validate
Moderator: Oleg
- plykkegaard
- Posts: 61
- Joined: Sun Dec 07, 2014 12:56 pm
- Location: Denmark
- Contact:
Re: Unable to validate
Just in case: If you need two copies of ZModeler running, put them into different folders and start from different folders.
- plykkegaard
- Posts: 61
- Joined: Sun Dec 07, 2014 12:56 pm
- Location: Denmark
- Contact:
Re: Unable to validate
Same license (same PC)?
Sometimes i'd be nice to be able to check settings for imported game models versus my own new models created from scratch
Sometimes i'd be nice to be able to check settings for imported game models versus my own new models created from scratch
Re: Unable to validate
Yes, on same PC, I'm doing that all the time.
Just be aware that any change to Zmodeler internal settings will be local because all Zmodeler files will exist twice. And a small hint: If you apply Zmodeler updates, with auto-update, be sure that then there is only one Zmodeler running. Otherwise the update will be offered and installed again and again. You would have to update both Zmodeler installations, in sequence, of course. Or simple overwrite the other directory with the updated one.
Just be aware that any change to Zmodeler internal settings will be local because all Zmodeler files will exist twice. And a small hint: If you apply Zmodeler updates, with auto-update, be sure that then there is only one Zmodeler running. Otherwise the update will be offered and installed again and again. You would have to update both Zmodeler installations, in sequence, of course. Or simple overwrite the other directory with the updated one.
- plykkegaard
- Posts: 61
- Joined: Sun Dec 07, 2014 12:56 pm
- Location: Denmark
- Contact:
Re: Unable to validate
Thnks Reinhard
Re: Unable to validate
Technical background: updates are downloaded, but not installed while ZModeler3.exe process is running. When you close ZModeler to let it install updates, an installing utility will wait for zmodeler3.exe process to finish prior to copy/replace files. If you run two copies of ZModeler, this will not happen and updates are not installed.